Filter
Top Products
VAV-SVN01E-EN 15
General
Infor mation
Literature Contents
This manual describes the installation
of VariTrane VAV units with recom-
mended wiring, piping, and mounting
of Single-Duct, Dual-Duct, Fan-Pow-
ered, Low-Height terminal units and
diffusers.
Receiving and Handling
VariTrane Units are shipped completely
assembled with the exceptions of
optional attenuators for fan-powered
units and accessories.
Upon receiving the equipment,
complete the following:
y Locate the nameplate and refer to the
model and sales order number and
check that the correct units have been
delivered.
y Inspect the control enclosures and air
valve casing for dents or punctures.
y Verify that all options have been
included, such as filters, controls,
heating coils, water valves, etc. Also
check that the unit voltages agree with
the building parameters.
y Manually rotate the fan (if applicable) to
assure that there are no obstructions
within the housing.
y Claims for in-transit damage must be
filed immediately with the delivery
carrier.
y For hot water re-heat units, check the
coil fins and make sure that coils are
not damaged.
y Locate and verify that the correct zone
sensors are with the order. These will be
marked with an orange “Accessories
Enclosed” label. Store in a secure
location until needed. Accessories lost
at the jobsite are NOT covered by
Trane’s warranty.
NOTICE:
Warnings and Cautions appear at appropriate sections throughout this manual.
Read these carefully.
– Indicates a potentially hazardous situation which, if
not avoided, could result in death or serious injury.
– Indicates a potentially hazardous situation which, if
not avoided, may result in minor or moderate injury. It may also be used
to alert against unsafe practices.
– Indicates a situation that may result in equipment or
property-damage-only accidents.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
y If a discrepancy occurs between what
was ordered and what is received,
contact you local Trane representative
immediately.
y Read the appropriate section in this
manual for installation procedures prior
to actual starting of equipment.
Upon receiving the equipment, please
inspect each unit and components for
external or internal damage. Refer to
the bill of lading to insure all equipment
and accessories have been received.
Contact your local Trane sales
representative and notify the trucking
company immediately of any short ship
or damaged equipment.