Trane RAUC-C40 Air Conditioner User Manual


 
6 SS-SVX09A-EN
General Information
Evaporator Nameplate
(EVP Chiller Applications Only)
The nameplate is located on the same side of the refrigerant connections near the top. To view the
nameplate, remove the tape over the area and spread the insulation. Retape the insulation after
viewing.
Unit Description
All air cooled condensing units are designed for outdoor installations with vertical air discharge.
These units may be installed on a flat roof or placed on a concrete slab at ground level.
Before shipment, each unit is leak-tested, evacuated, a Nitrogen holding charge is added, and the
controls are tested for proper operation.
The condenser coils are aluminum fin, bonded to copper tubing. Copper-fin coils are optional.
Louvered condenser grilles for coil protection are standard. Direct-drive, vertical discharge
condenser fans are provided with built-in current and overload protection.
For “Ship with” items, refer to the Unit Component “Layout” and “Ship with” Locations
illustration.
If low ambient operation is required, low ambient dampers are available as a field or factory
installed option.
These units may be order with one of the following options:
No System Controls (Field provided controls required)
Constant Volume Controls
Supply Air Temperature Control (VAV applications)
EVP Chiller Controls
Basic unit components include:
Manifolded Scroll Compressors
Intertwined condenser coils
Condenser fans (number based on unit size)
Discharge service valve (one per circuit)
Liquid line service valve (one per circuit)
Figure 1. Unit Component Layout and ‘shipwith’ Locations (60 Ton Unit Illustrated)