Filter
Top Products
STE 58792
– 10 –
2.4 Tool Wiring and Piping
This paragraph describes the wiring and air piping for the tool.
2.4.1 Tool Wiring
For the tool wiring, see the descriptions on tool wiring (Para. 4.2.2) included in the
Transportation and Installation Manual.
For the wiring, be sure to use the connector at the lower side of arm 2.
2.4.2 Tool Air Piping
In all, two (2) air pipelines (outer dia. 6 mm × inner dia. 4 mm) are available for the
tool. Figures 2.5 and 2.6 show the joint locations of these pipelines.
Lower side of arm 2 Rear side of fixed base
Figure 2.5 Location of SR–654HSP–CR piping joint
Lower side of arm 2 Rear side of fixed base
Figure 2.6 Location of SR–1054HSP–CR piping joint