Filter
Top Products
Toshiba XXXXXXX(X/X)
–8–
4-way Air Discharge Cassette Type
Owner’s Manual
EN
4 CORRECT USAGE
• When you use the air conditioner for the first time or when you change the SET DATA value, follow the
procedure below. From the next time, the operation displayed on the remote controller will start by
pushing the button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote
controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx.
1 minute, but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with button without turning off the main power
switch and the leak breaker.
• When you use the air conditioner after it has not been used for a long period, turn on the leakage
breaker at least 12 hours before starting operation.
Start
1 Push button.
The operation lamp goes on, and the
operation starts.
2 Select an operation mode with the
“MODE ” button.
One push of the button, and the display
changes in the order shown as follows.
3 Select air volume with “ ” button.
One push of the button, and the display
changes in the order shown as follows.
• When air volume is “ AUTO”, air
volume differs according to the room
temperature.
• In heating operation, if the room
temperature is not heated sufficiently with
VOLUME “ LOW” operation, select
“ MED.” or “ HIGH” operation.
• The temperature sensor senses
temperature near the suction air port of the
indoor unit, which differs from the room
temperature depending on the installation
condition.
A value of setting temperature is the
measure of room temperature.
(“AUTO ” is not selectable in the FAN
mode.)
4 Determine the set up temperature by
pushing the “TEMP. ” or “TEMP.
” button.
Stop
Push button.
The operation lamp goes off, and the operation
stops.
In the COOL, DRY, or AUTO (cooling) mode, the
fan runs for 10 minutes (or more) for self cleaning.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
1
3
2
4
AUTO HEAT DRY COOL FAN
LOW MED. HIGH
AUTO
8-EN
+00EH99930901-2_10L_4-way_OM.book Page 8 Friday, April 17, 2009 2:39 PM