Filter
Top Products
Toshiba XXXXXXX(X/X)
–12–
4-way Air Discharge Cassette Type
Owner’s Manual
EN
How to set up the wind direction
1 Push during operation.
The wind direction changes for every push of
the button.
In HEAT operation
Direct the louver (adjustment plate of up/down
wind direction) downward. If directing at
horizontally, hot air may not come to the foot.
In COOL/DRY operation
Direct the louver (adjustment plate of up/down
wind direction) horizontally. If directing it
downward, the dew may form on the surface of the
air discharge port and may drop down.
In FAN operation
Select a desired wind direction.
How to start swinging
1 Push , set the louver (adjustment
plate of up/down wind direction)
direction to the lowest position, and
then push again.
SWING is displayed and the up/down
wind direction is automatically selected.
Display during swinging
How to stop swinging
1 Push at a desired position while
the louver is swinging.
• When is pushed after that, wind
direction can be set again from the
highest position.
Display when swinging is stopped
In this case, push again two seconds
later.
• In COOL/DRY operation, the louver does
not stop as it directs downward. If stopping
the louver as it directs downward during
swing operation, it stops after moving to the
third position from the highest position.
Display when stopping the swing
Unit select button
• When multiple indoor units are controlled with
one remote controller, wind direction can be set
for each indoor unit by selecting individually.
• To set wind direction individually, push
button to display an indoor unit number in the
control group. Then set the wind direction of the
displayed indoor unit.
• When no indoor unit number is displayed, all
indoor units in the control group can be
controlled simultaneously.
• Each time you push button, the display
changes as follows:
1
Unit select button
Initial setup
Initial setup
Initial setup
Repeat
* However, even if is pushed while
the louver is swinging, the louver position is
displayed as follows and highest position of
the louver may not be selected.
FAN/HEAT
operation
COOL/DRY
operation
FAN/HEAT
operation
COOL/DRY
operation
Not
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
12-EN
+00EH99930901-2_10L_4-way_OM.book Page 12 Friday, April 17, 2009 2:39 PM