Filter
Top Products
49
PRECAUTIONS FOR SAFETY
WARNING
WARNINGS ABOUT INSTALLATION
• Make sure to ask the qualified installation professional in
electric work to install the remote controller.
If the remote controller is inappropriate installed by
yourself, it may cause, electric shock, fire, and so on.
WARNINGS ABOUT OPERATION
• When you are aware of something abnormal with the air
conditioner (smells like something etc.), immediately turn
off the main power supply switch or circuit breaker, from
the mains to stop the air conditioner, and make contact
with the dealer. If the air conditioner is continuously
operated with something abnormal, it may cause machine
failure, electric shock, fire, and so on.
WARNINGS ABOUT MOVEMENT AND REPAIR
• Do not repair any unit by yourself.
• Whenever the air conditioner needs repair, make sure to
ask the dealer to do it. If it is repaired imperfectly, it may
cause electric shock or fire.
CAUTION
CAUTIONS ABOUT OPERATION
• Carefully read this manual before starting the air condi-
tioner. There are many important things for the safety and
the correct usage.
• Do not touch any switches with wet finger, otherwise you
may get an electric shock.
• When the air conditioner was not be used for a consider-
ably long time, turn off the main switch or the circuit
breaker, for safety. Disconnect from the power supply
prevents the unit from lightning and power supply surge.
• Prevent any liquid from falling into the remote controller.
Do not spill juice, water or any kind of liquid.
NAME AND OPERATION
Remote Controller
• Max. 8 indoor units can be operated by a remote controller as a group.
1
Transmitting part
2
Remote controller sensor
The peripheral temperature is sensed when
the sensor button is pushed to remote
controller side.
3
Mode display section
The operation mode is displayed.
4
Start/Stop button
Pushing this button starts, and pushing
again stops the unit.
5
Mode Select button
Pushing this button selects an operation
mode.
6
Air volume button
7
Time Setup button
This button is used when the timer is
setup.
8
Reset button
This button is used after replacement of
battery or selection of slide switch.
9
Slide switch
10
Part storing batteries
11
Cover
Slide the cover holding its both sides.
12
AUTO flap display differs according
to the installed unit.
13
Setup Temp. button
Every pushing this button, temperature
rises by 1˚C.
Every pushing this button, temperature
lowers by 1˚C.
14
Filter button
The remote controller is not operated
even if this switch is pushed.
15
Swing/Air direction button
16
Address button
17
Ventilation button
The remote controller is not operated
even if this switch is pushed.
18
Sensor button
This button is used when selecting the
temp. sensor at the remote controller
side. At the shipment from the factory,
this button is set to the temp. sensor at
the indoor unit.
SET
ACL
SENSOR
CL
SKN AHC
ADR
ADR
1
2
4
6
8
5
7
9
10
11
14
3
16
13
12
15
17
18
ACCESSORIES