Filter
Top Products
–32–
SMMS-i
Installation Manual
EN
SMMS-i
Installation Manual
*1PDU number information
01:Compressor 1
02:Compressor 2
03:Compressors 1 and 2
04:Compressor 3
05:Compressors 1 and 3
06:Compressors 2 and 3
07:Compressors 1, 2 and 3
08:Fan
09:Compressor 1 and fan
0A:Compressor 2 and fan
0B:Compressors 1, 2 and fan
0C:Compressor 3 and fan
0D:Compressors 1, 3 and fan
0E:Compressors 2, 3 and fan
0F:Compressors 1, 2, 3, and fan
P07
01: Compressor 1
02: Compressor 2
03: Compressor 3
Heat sink overheat error
P10 Detected indoor unit address Indoor overflow error
P13 — Outdoor unit flow back error detected
P15
01: TS condition
02: TD condition
Gas leak detection
P17 — Discharge temperature TD2 error
P18 — Discharge temperature TD3 error
P19 Detected outdoor unit number 4-way valve inverse error
P20 — High-pressure protective operation
P22
0 *: IGBT circuit
1 *: Position detection circuit error
3 *: Motor lock error
4 *: Motor current detected
C *: TH sensor error
D *: TH sensor error
E *: Inverter DC voltage error
(outdoor unit’s fan)
Outdoor fan IPDU error
(NOTE)
Ignore 0-F appearing in the position of “*”.
P26
01: Compressor 1
02: Compressor 2
03: Compressor 3
G-TR short protection error
P29
01: Compressor 1
02: Compressor 2
03: Compressor 3
Compressor position detecting circuit error
Check code
Check code nameIndication on 7-segment display on the outdoor unit
Auxiliary code
12 MACHINE CARD AND LOGBOOK
Machine card
After test run, fill the items on the machine card and paste the card on an accessible place on the product securely before
delivery to the customer.
Describe the following items on the machine card:
name, address and telephone number of the installer, his service department, the service department of the party concerned
or at any addresses and telephone numbers of fire department, police, hospitals and burn centres;
Logbook
Update the log periodically after maintenance as defined in EN378-4.
Describe the following items on the logbook:
1. details of the maintenance and repair works;
2. quantities, kind of (new, reused, recycled) refrigerant which have been charged on each occasion, the quantities
of refrigerant which have been transferred from the system on each occasion (see also EN378-4);
3. if there is an analysis of a reused refrigerant, the results shall be kept in the logbook;
4. source of the reused refrigerant;
5. changes and replacements of components of the system;
6. result of all periodic routine tests;
7. significant periods of non-use.
63-EN 64-EN
+00EH99871699_01EN.book Page 32 Thursday, August 26, 2010 4:41 PM