Filter
Top Products
NOTE: In order to achieve maximum room cooling efficiency, the exhaust duct should remain as short and straight
as possible. To further shorten the exhaust hose, first unthread either exhaust duct adapter clockwise to remove it.
Then cut the hose to desired length. It is not recommended to increase the manufacturer’s length of the exhaust
hose. This may reduce the cooling efficiency or damage the unit
WINDOW KIT INSTALLATION
a) Open window or sliding door approximately 5
inches (13 cm). Adjust the length of the window
kit to the same length of the window or sliding
door. Use two or three panels if necessary and
secure panels into place by fastening the ¾”
Phillips head screws into the pre-drilled panel
holes.
b) Alternatively you may need to mark a single
panel and cut it down to properly fit the window
opening. The window kit (three panels) has a
maximum length 81 inches.
c) Place the window kit between the window and the
window frame as shown in the picture to the
right. Close the window onto the window kit to
form a tight seal.
d) Attach the exhaust duct window kit adapter to the
window kit. Tabs located on the adapter will lock
into place securing the adapter to the window kit.
NOTE: Using the window kit will cause the window not to be properly closed and locked. Consider taking
additional security measurements.
CONTROL PANEL AND LCD SCREEN
9