Filter
Top Products
are installed or replaced, the clock is set to 12:00AM. To set present
time:
2.
Cooling Operation
a. Be sure that the drain bucket is properly placed in the unit. If the drain bucket is not
properly secured, the red “Water Full” light located on the front panel will blink
and the unit will not begin cooling.
b. Be sure the exhaust duct properly installed. Refer to page 6 for exhaust duct
installation.
c. Plug the Power Cord to the power outlet.
d. Press the ON/OFF key to turn on the unit
e. Press the Mode key until the LCD displays “COOL”
f. Press either of key of the Temperature key until the LCD displays the
desired temperature
g. Press the Fan Speed key until the LCD displays the desired fan speed.
3. Heating Operation
12