SkyLink 91562-01 Garage Door Opener User Manual


 
3
1
2
is06715
1. Transmitter mounting location
2. Wires to headlamp
3. Ignition module
Figure 7.Transmitter Mounting and Wire Routing, (2003
or Earlier Sportster Models)
2004 and Later Sportster Models
1. Remove the fuel tank. See the correct section (Carbureted
or EFI Engine) of the service manual.
2. Remove the electrical side cover, located on the left side
of the motorcycle near the battery.
3. See Figure 27. Position the transmitter (1) behind the
electrical side cover. Orient the transmitter so the printed
circuit side faces away from the battery, and fasten the
transmitter to the wire harness next to the main fuse holder
using cable straps (8) from the kit.
Proceed to the Harness Connection section.
FLHR Touring Models
1. Remove the headlamp from the nacelle per the instructions
in the service manual.
2. Remove the liner from the adhesive backing of the tape
pad on the transmitter.
3. See Figure 8. Mount the transmitter to the right side of the
frame near the fork tube.
Proceed to the Harness Connection section.
is06716
Figure 8.Transmitter Mounting Near Fork Tube (FLHR)
FLHT, FLHX and FLTR Touring Models;Trike Models
1. Remove the outer fairing per the instructions in the service
manual.
2. Remove the liner from the adhesive backing of the tape
pad on the transmitter.
3. See Figure 9 (FLHT, FLHX models) or Figure 10 (FLTR
models). Mount the transmitter to the upper inside of the
fairing.
Proceed to the Harness Connection section.
4
6
5
3
2
1
is06717
1. Mount transmitter to fairing
2. Headlamp connector
3. Orange/white wire
4. Black wire
5. White wire
6. Yellow wire
Figure 9.Wires for Transmitter Connections (FLHT/X)
-J02028 5 of 16