Filter
Top Products
2000 and Later Softails, Except Deuce (FXSTD)
1. Remove the fuel tank mounting bolts. See the correct
section (Carbureted or EFI Engine) of the service manual.
2. Remove the rear splash guard (inner fender) per service
manual instructions.
3. See Figure 4. Use cable straps from the kit to fasten the
transmitter (3) to the wire harness located between the
frame, rear fork (2), and rear tire (1).
4. See Figure 5. Route the transmitter wires (2) up to the
battery compartment (4) and along the right side of the
frame.
Proceed to the Harness Connection section.
2
3
1
is06711
1. Rear wheel and tire
2. Rear fork
3. Transmitter
Figure 4.Transmitter Mounting, 2000 and Later Softails,
Except Deuce (FLSTC Shown)
4
3
2
1
is06712
1. Ground connection
2. Transmitter wires to headlamp
3. Orange/white wire
4. Battery compartment (reference)
Figure 5. Power and Ground Connections, 2000 and Later
Softails (FLSTC Shown)
2000 and Later Softail Deuce (FXSTD)
1. Remove the fuel tank mounting bolts. See the correct
section (Carbureted or EFI Engine) of the service manual.
2. Remove the liner from the adhesive backing of the tape
pad on the transmitter.
3. See Figure 6. Mount the transmitter to the surface below
the ECM/ignition module. Route the transmitter wires for-
ward along the right side of the frame.
Proceed to the Harness Connection section.
3
1
2
4
is06713
1. Ground connection
2. Orange/white wire
3. Transmitter
4. ECM/ignition module
Figure 6.Transmitter Mounting, 2000 and Later Deuce
1994-2003 Sportster Models
1. Remove the fuel tank. See the correct section (Carbureted
or EFI Engine) of the service manual.
2. See Figure 7. Position the transmitter (1) to the main wire
harness in the area under the seat, as far as possible from
the oil tank, and fasten the transmitter to the harness using
cable straps from the kit.
Proceed to the Harness Connection section.
-J02028 4 of 16