SkyLink 91562-01 Garage Door Opener User Manual


 
2
1
is06727
1. White and yellow headlamp wires
2. Cut headlamp wire casing to access wires
Figure 25.White and Yellow Wire Optional External Splice
Location (Sportster Models)
3. Cut the yellow and white wires in the headlamp housing
several inches from the headlamp connector. Cut excess
length from the yellow and white transmitter wires if
necessary. Cut to allow enough wire to easily strip and
splice the wires.
4. See Figure 15, the 1 into 1 splice configuration. Use a
blue sealed splice connector (Figure 27, Item 5) from the
kit to splice the white transmitter wire to the white head-
lamp wires. Use the remaining blue sealed splice con-
nector to splice the yellow transmitter wire to the yellow
headlamp wires.
5. Proceed to the Receiver and Transmitter Programming
section to program the garage door opener controls.
V-Rod Models
1. Cut the yellow and white wires in the main vehicle harness
headlamp circuit at an accessible point several inches
from the headlamp connector. Cut excess length from the
yellow and white transmitter wires if necessary.Trim back
the transmitter wire harness casing as needed to assist
splicing. Cut to allow enough wire to easily strip and splice
the wires.
2. See Figure 27. Slide the woven wire conduit (9) from the
kit over the yellow and white transmitter wires.
3. See Figure 15, the 1 into 1 splice configuration. Use a
blue sealed splice connector (Figure 27, Item 5) from the
kit to splice the white transmitter wire to the white head-
lamp wires. Use the remaining blue sealed splice con-
nector to splice the yellow transmitter wire to the yellow
headlamp wires.
4. Slide the woven wire conduit over the yellow and white
wire connections after splicing.
5. Install the front left louvered cover onto the motorcycle.
6. Proceed to the Receiver and Transmitter Programming
section to program the garage door opener controls.
-J02028 13 of 16