Filter
Top Products
23
CONTRACTOR
CAUTION: To prevent valve seat damage, never adjust the
humidifier's water level without supporting the float arm. Make
adjustments in small increments.
•To raise the water level, push down in the center of the float arm
(see Figure 9, below).
•To lower the water level, hold the float on the bottom of the reser-
voir with one hand and pull up on the center of the float arm with
the other hand (see Figure 10, below).
Figure 9: Raising the Water Level
Figure 10: Lowering the Water Level
5. If the water level is too high, remove enough water from the reservoir
to allow the float valve to automatically fill and shut off the water. This
will verify that your final adjustment is correct.
6. Mount the humidifier according to one of the options shown on pages
10-17.
7. Route the tubing to the humidifier float valve, keeping the tubing away
from sharp edges.
8. Connect the remaining end of the tubing to the humidifier float valve.
9. Open the saddle valve so that the water flows slowly and gently into
the water pan.