Filter
Top Products
72
USING THE EVEN-FEED
FOOT
The Even-feed foot accessory equalizes the
feeding of the upper and lower layers of fabric and
improves the matching of plaids, stripes, and
patterns. This foot helps to prevent uneven
feeding of very difficult fabrics.
No. 1, 2, or 8
Even-feed foot
A.ATTACHING THE EVEN-FEED FOOT
1. Remove the presser foot and holder. (See page
14)
2. The arm of even-feed foot should ride onto the
shaft of the needle clamp screw.
3. Slide the attaching head from your left to right
so that it is fitted into the presser bar.
4. Tighten the presser foot thumb screw.
B.SEWING
Hold both thread lightly at start of sewing and sew
in slow (1/2) speed.
CONTINUOUS
DECORATIVE PATTERN
Use the satin foot for continuous decorative stitch
patterns.
This foot has a full indentation on the underside to
permit easy over closely spaced zigzag stitches,
and even feed of the fabric.
No. 17-90
Satin foot
To tailor the continuous decorative stitch pattern,
you may adjust the length and width of pattern.
Also you may change reverse or mirror stitch of
pattern and elongate the pattern.
Experiment with fabric scraps until you get the
desired length and width.
A.SEWING THIN FABRICS
When sewing thin fabrics, it is suggested that you
use interfacing on the backside of the fabric.
2003.9.10, 8:33 PM72