Filter
Top Products
-- 7 --
7
HEAT mode operation procedure
3.Press SWING button, the
louvers start to rotate auto-
matically, and stop when re-
press it.
4.Press FAN button, set fan
speed.
5.Press TEMP. button, set
suitable SET TEMP.
1.Plug in, press 1/0 button,
then air conditioner is turned
on.
2.Press MODE button, set
operation mode.
1/0
If room temp. is lower than set temp. , compressor runs at HEAT mode;
If room temp. is higher than set temp., compressor and outdoor fan motor stop, only indoor
fan motor runs, louver motor makes the louvers horizontal, after about one minute, indoor
fan motor will stop .
SET TEMP. should be in range of 16
o
C to 30
o
C.
When the unit (cool only) recieved the con-
trol signal which is used under the heat mode,
it will operate according to the FAN mode.
66162002 6 02 11 30 10 247