Filter
Top Products
G8860 _4 Installation Manual NZ
23
25.1 When installing a 4 sided fascia ensure that the clips that the outer fascia screw into are at
the bottom of the slot on which they are attached as shown below. The outer fascia should
be pushed down onto the top lip so that it is as low as possible and the screw holes in the
fascia line up with the lowered clips.
25.2 This is especially important for the IB600 as a good gap between the bottom of the 4 sided
outer fascia and the removable bottom fascia strip is vital for ventilating the electronics tray.
If this is not done the fire can produce an “E1” electronic over temperature error.
26.0 Locating Wall Mount Cradle for Wireless Control;
The heaters remote contains the thermostat that will sense the room temperature and
communicate this back to the heater via radio frequency.
A wall mount cradle has been provided for the wireless control and where possible the
control should be housed in this cradle.
The location of this cradle should be decided by taking into account the following factors;
1. Simple, convenient access for the user
2. Away from air flow and drafts through the room
3. The parts of the room that people are likely to spend time
4. Away from direct sun light
5. A suitable distance away from the heater.
6. Ideally 1.2m to 1.5m from the floor
The radio frequency signal will go through some walls but for best results escea suggest that
the cradle position is between 5 and 15 metres away from the heater.
The best height off the ground to locate the cradle is about chest height. This gives a good
average room temperature and easy access for the user.
Please ensure that cradle is screwed firmly onto the wall using the screws provided.
Top lip