Filter
Top Products
G8860 _4 Installation Manual NZ
11
12.3 IB1100: The IB1100 Outer Skin Kit has 4 possible entry points for solid gas pipe, on the four
corners of the kit. Each is sealed by a ‘knock-out’. Remove only the knock-out which you
require, and place the supplied rubber plug into the hole. You will need to make a small cut
into the rubber plug to allow the gas pipe to pass through, keeping the plug as air-tight as
possible.
13.0 Assembling the Outer Skin Kit (IB1100 Only):
Included in the OSK is:
- 1x Top-Rear panel
- 1x Top-Front panel
- 2x Side panels
- 1x Rear panel
- 1x Base panel
- 1x Flue Support Bracket
13.1 Attach the Sides to the Base:
Attach Side panels to Base, make sure
Base panel flanges are on the outside,
and the large flange of the Side panels
faces the front.
The Right Side has a rectangular cutout,
It is important that this is on the right hand
side and that the circular knock-outs are
at the base of the Outer Skin Kit as pictured.