Filter
Top Products
G8860 _4 Installation Manual NZ
14
Step 2: Lift out glass and place it carefully aside.
18.0 Connecting Flue to Heater:
This is a 7 step process and is performed after the heater has been pushed into position in
the cavity and before fascia panels have been fitted.
1) Remove glass as shown above.
2) Remove the log set and its associated packaging from the fire box.
3) Remove the top of the heater outer shell. Take out the screw from each side (as shown
below) and pull the top of heater shell out towards yourself.
4) For best access we recommend removing the fire box. Undo the four screws on the front
four corners of the fire box and the two screws on the inside holding down the fire box
(as shown below). Pull the fire box out of the heater.