Filter
Top Products
7
INSTALLATION
Before You Begin
The following instructions outline a typical water treatment system installation. Consult local
plumbing codes and building regulations as they may pose different or additional requirements for
the installation. The installer is responsible for ensuring that the installation is in compliance with all
applicable state and local regulations.
This system has been designed for installation by a licensed professional such as a contractor or
plumber. Proper completion of this installation will require basic familiarity with standard sink
plumbing and proper use of common hand and power tools. Improperly installed systems could result
in water damage due to leaks or flooding.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
1
A. Product water storage tank I. Product water tubing (3/8" blue)
B. Tank shut-off valve J. Reverse osmosis membrane filter
C. Tank tubing (3/8" white) K. Carbon post-filter
D. Air-gap faucet L. Pre-filter
E. Drain connection assembly M. Automatic shut-off valve
F. Drain tubing (3/8" white) N. Inlet fitting with elbow
G. Quick-connect fitting O. Feed water tubing (1/4" green)
H. Drain tubing (1/4" yellow) P. Feed water shut-off
Typical Installation Diagram