Filter
Top Products
Cleaning the Shutlle Race
This area must be kept free of dust, lint and
occasional tangled thread Clean the shuttle race area
about every three months.
o Cleaning the shuttle area
(_ Bobbin case
(_) Levers
Q Shuttle race cover
(_) Shuttle
(_ Shuttle race
(_}') Center pin on the shuttle
Q Shuttle driver
Pointed hook
0 (Oil here)
1- Raise the needle bar to its highest point and remove the
bobbin case (_,
2 Push shuttle race levers (_ aside Lift shuttle race
cover (_Dand take shuttle @ out
3, Clean the shuttle race Owith a lint brush
4, Put a drop of oil on the center pin of the shuttle (_) and
shuttle race 0 Do not over oil
o Replacing shuttle assembly
0 Bobbin case
(_) Levers
(_ Shuttle race cover
0 Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
(Z) Shuttle driver
Pointed hook
@ (Oil here)
1 Position shuttle race (_) as illustrated so that shuttle
driver (Z) is forming half moon on the left side of the
machine
2, Hold shuttle (_ by center pin (_ and position shuttle so as
to form a half moon on the right side The pointed hook(_
will be on the bottom
3 Place shuttle race cover (_) into place over shuttle
assembly
4., Snap the levers (_) back into the original position
0
®
64