Filter
Top Products
SECTION III..STRAIGHT STITCH SEWING
Straight Stitch
O Stitch selector: 1 or 2
® Stitch length: Red zone
® Needle thread tension: 2 to 6
(_ Presser foot: Straight stitch foot
(_) Presser foot: Zigzag foot
NOTE: When using the straight stitch foot, make sure to set
the stitch selector at t (Center needle position)
Otherwise the needle may strike the sewing foot and
possibly break.
• Starting to sew
Raise the presser foot and position the fabric next to a seam
guide line on the needle plate (5/8" is most common)_
Lower the needle to the point where you want to start Lower
the presser foot and pull the threads toward the back. De-
press the foot control. Gently guide the fabric along a seam
guide line letting the fabric feed naturally.
o Finishing sewing
To fasten the ends of a seam, press the reverse stitch control
and sew several'reverse stitches. Raise the presser foot.
Remove the fabric, draw the threads to the back and cut them
with the thread cutter. The threads are cut in a proper length
for the next seam
I
t
l
1
© ®
LENOTH
or
o
OU
Use.the Seam Guides
(_ Cornering guid e
® Guide lines in inches
(_) Guide lines in millimeters
The seam guides on the needle plate are there to help you
measure seam width The lines are ti8" (0.3 cm) apart, with
the 3/8", 4/8", 5/8" and 6/8" lines engraved The lines in miF
timeters are 5 mm apart, with the 10 ram, 15 mm and 20 mm
lines engraved
Turn a Square Corner
O Cornering guide
'To turn a square coiner 1.6 cm (5/8") from the fabric edge
1. Stop stitching and lower the needle by turning
handwheel cour_terctockwise, toward you, when the
fabric edge facing you lines up with the edge of the needle
plate as shown.
2. Raise the presser foot and turn the fabric to line up the
edge with the 16 cm (5t8") seam guide
3. Lower the presser foot and begin stitching in the new
direction
32