IMPORTANT SAFETY INSTRUCTIONS
Your sewing machine is designed and constructed onty for HOUSEHOLD use
Read all instructions before using this sewing machine.
DANGER --To reduce the risk of electric shock:
1o This sewing machine should never be left unattended when plugged in. Always unplug this sewing machine fro_ the,
electric outlet immediately after using and before cleaning..
2.. Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated 15 Walls.
3.. Do not reach for a sewing machine that has fallen into water. Unplug immediately.
4. Do not place or store this sewing machine where it can fall or be pulled into a tub or sink_ Do notplaca or drop it into water
or other liquid.
WARN ING --To reduce the risk of bums, fire, electric shock, or injury to persons:
t. Do not allow this sewing machine to be used as a toy Close attention is necessary when this sewing machine is used by
or near children.
2_ Use this sewing machine only for its intended use as described in this owner's manual°
Use only attachments recommended by the manufacturer as contained in this owner's manu'al.
3 Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water
Return this sewing machine to the nearest Sears stere or service center for examination, repair, electrical or mechanical
adjustment
4. Never operate this sewing machine with any air opening blocked Keep ventilation openings of this sewing machine and
foot controller free from accumulation of lint, dust and loose cloth.
5 Never drop or insert any object into any opening..
6. Do not use outdoors.
7.. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8. To disconnect, turn al! controls to the off (" O") position, then remove plug from outlet
9. Do not unplug by pulling on cord.. To unplug, grasp the plug, not the cord.
t0_ Keep fingers away from all moving pads, Special care is required around the sewing machine needle°
11. Always use the proper needle plate. The wrong plate can cause the needle to break.
12. Do not use bent needles
13..Do not pull or push fabric while stitching It may deflect the needle causing it to break..
14. Switch this sewing machine off (" O") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin er changing the presser foot, and the like,
15 Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual
SAVE THESE INSTRUCTIONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run
the machine without thread for a few minutes° Wipe away any oil which may appear.