Filter
Top Products
8
indoor
wall
pipe
25
."
sealing gum
protective
pipe
outdoor
INDOOR UNIT INSTALLATION
INSTALL THE REAR PANEL-MOUNTING PLATE
Always mount rear panel horizontally.
Hold the rear panel on the wall where you want the unit to be located and ensure that it is level
using a plumb line or level. Once leveled, mark the screw locations on the wall.
Fasten the rear panel to the wall at the location marked using the screws supplied with the unit.
Insure that the panel has been mounted firmly to withstand the weight of the unit for about 132 lbs,
with the weight being evenly distributed by each screw.
INSTALL THE PIPING HOLE
Select the location for the piping hole - either left-positioned or
right-positioned (see installation dimension diagram).
Make piping hole in the wall approximately 2.5 inches in diameter at a
slight downward slant (this ensures proper drainage).
Insert a piping-hole sleeve in the hole (i.e. PVC pipe) to prevent the
connection piping and wiring from being damaged
INSTALL DRAINAGE HOSE EXTENSION (OPTIONAL)
Drainage hose extension is included with unit, for use if attached drainage line is not long enough
for your application.
Please note that the extension can be installed after
existing drainage pipe is fed through wall later in the
installation process, if it is determined later that it is
necessary.
Do not wrench or bend drainage hose or extension.
WIRE THE INDOOR UNIT
CAUTION: All electrical wiring must be done by a qualified technician in accordance with
local electrical codes.
A separate circuit breaker must be provided.
AC power for the indoor unit is provided by the power cable that runs between the outdoor unit and
the indoor unit.
If a disconnect switch is required for the indoor unit, it must be properly rated. Disconnect switch
may be installed by breaking the individual wires connected to pins (N1) and (3) of the control
cable. See table 1 for recommended value.
ridge
twist