Filter
Top Products
86
U
D
■ TROUBLESHOOTING
If your air conditioner does not work properly, first check the following points before requesting service. If it still does not work
properly, contact your dealer or a service center.
Air conditioner does not run at all 1. Power failure. 1.
After a power outage, press ON/OFF operation button
on the
wired remote control unit.
2. Leakage circuit breaker has
tripped.
2. Contact service center.
3. Line voltage is too low.
3. Consult your electrician or dealer.
4. Operation button is turned off.
4. Press the button again.
5. The wired remote control unit or
heat pump is
(
The inspection mark and the
letters E, F,
H, L, P in
combination with numbers
appear
the LCD of the wired
remote control unit.)
5. Consult your dealer.
Compressor runs but soon stops 1. Obstruction in front of condenser coil 1. Remove obstruction
P
oor cooling (or heating)
performance
1. Dirty or clogged air filter.
1. Clean air filter to improve the
2. Heat source or many people in
room.
2. Eliminate heat source if possible.
3. Doors and/or windows are open.
3. Shut them to keep the heat (or
cold) out.
4. Obstacle near air intake or air
discharge port.
4. Remove it to ensure good airflow.
5. Thermostat is set too high for
(or too low for heating).
5. Set the temperature lower (or
higher).
6. (Defrosting system does not work.)
6. (Consult your dealer.)
Trouble
Possible Cause
Remedy
airflow.
cooling
malfunctioning.
on
■ Tips for Energy Saving
Avoid
Do
• Do not block the air intake and outlet of the unit. If either is obstructed, the unit
will not work well, and may be damaged.
• Do not let direct sunlight into the room. Use sunshades, blinds or curtains. If the walls
and ceiling of the room are warmed by the sun, it will take longer to cool the room.
• Always try to keep the air filter clean. (Refer to “Care and Cleaning.”) A clogged filter
will impair the performance of the unit.
• To prevent conditioned air from escaping, keep windows, doors and any other openings
closed.
Should the power fail while the unit is running
If the power supply for this unit is temporarily cut off, the unit will automatically resume operation once power is
restored using the same settings before the power was interrupted.
NOTE
07-056 Mini_ECOi_II_NA 3/19/07 2:41 PM Page 86