Filter
Top Products
Hook
Screw
Hinge
Intake grille
Slide
Press on the tabs with a flathead (minus)
screwdriver while pulling out the intake grille.
Screw
37
A
Removing the intake grille
Slide the intake grille hooks (2 locations)
in the direction of the arrow to open the
intake grille. (fig. 3-49a)
When the intake grille is open, press a
flathead screwdriver against the rear
tabs (2 locations) and pull out the intake
grille. (Fig. 3-49b)
Removing the side panel
Grasp the finger grip on the side panel
and slide the panel in the direction of
arrow to remove the panel.
(There are 2 panels: 1 each on the left
and right sides.) (Fig. 3-51)
1
Fig. 3-50
Side panel
Slide
Tab
1
Fig. 3-49a
Fig. 3-49b
Fig. 3-51
3-13-2. Installing the ceiling panel
(1) Fasten the hooks on both sides of the ceiling panel to
the indoor unit. The hooks on one side (2 locations) are
stationary, while the hook on the other side is move-
able. (Fig. 3-52)
(2) Angle the panel somewhat and fasten the stationary
hook into the fastener on the side of the unit.
(3) After verifying that the hook is fastened, press the other
end up until the ceiling panel is level. Then press
upwards until the moveable hook is fastened into the
fastener on the unit.
(4) Verify that the hooks on both sides of the ceiling panel
are securely fastened to the unit. If the hooks are not
securely fastened, the panel may fall. At this point, the
panel is now provisionally fastened to the unit.
● When removing the panel, press the movable hook
toward the inside while supporting the panel. (Fig. 3-53)
Stationary hook
Press to remove.
Moveable hook
Moveable hook
Hook receiver
Fig. 3-52
Fig. 3-53
07-056 Mini_ECOi_II_NA 3/19/07 2:40 PM Page 37