Filter
Top Products
8_
Installation and External Connection
installation and external connection
INSTALLATION
Attach the provided rear panel to the wall and drill two 6-32 holes and one 1/2 inch hole on it. (See [Figure 1])
Refer to [Figure 2] below on how to secure the rear panel to the wall using the provided screws.
Apply each of 5 O-rings to the corresponding point as shown in [Figure 2].
Fix the main unit with the rear panel by inserting the main unit’s cables into the center hole and pushing the main
unit towards the rear panel.
Once the main unit is fi xed with the rear panel, it will not be loosened. Please check if the device is operating properly
before fi xing it.
If you try to remove the rear panel once it is fi xed, the lock parts of the rear panel will break, resulting in a situation where
the whole rear panel must be replaced.
1.
2.
3.
4.
J
[Figure 1] [Figure 2]