Filter
Top Products
E-13
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.
◆
In the case of an area where the drain pan can not be directly
installed on the rear side of the unit after installing the air conditioner.
Example:
High storage
◆
In the case of an area where the drain pan can be directly installed
on the rear side of the unit after installing the air conditioner.
Remove two screws on the lower, right and left sides of the unit.
4
Hold the handle of the air filter, pull it slightly forward, and then pull it
out to the right side.
1
Remove the screw.
2
Remove the chassis from the cabinet.5
Remove the rubber cap inserted into the basepan.6
Fix the drain pan as shown in the figure, and then connect the drain hose.
(You can use any commercially-available drain hose.)
7
Install the cabinet at the specified area after installing the drain pan,
and then re-assemble it in the original condition.
8
Follow steps 6 and 7 only1
Disassemble the front grille.
3-1 Hold the lower part of the front grille, and then move it slightly to
the left side.
3-2 Pull the lower part of the front grille slightly forward.(below three inches)
3-3 Lift the front grille upward.
3
Applying excessive force to disassemble the front grille
may cause damage to the tab ; be sure not to use
excessive force.
Rubber cap
Screws(2EA)
Gasket
Rear
Drain Tube
☛
Screw
Front grille
Rear
Screw
Drain Pan
Rubber cap
Drain Hose
Bottom-Side View with
Drain Pan and Hose in Place