Filter
Top Products
SECTION 9: TROUBLESHOOTING
39
BURNER DOES NOT STAY LIT
Possible Cause Try this....
Damaged wires between DSI Replace wires as required.
module and sensing electrode.
Faulty DSI module. Replace DSI module.
Cracked ceramic at the Replace electrode.
sensing electrode.
Recirculation of Check that the 3” (80 mm) inner vent pipe is completely sealed.
exhaust gases.
BURNER CYCLES ON AND OFF TOO QUICKLY
Possible Cause Try this....
Anticipator setting on Adjust the anticipator setting to 0.6. See Page 20, Figure 12.
the thermostat is too low
.18
.2
.25
.3
.4
.5
.7
.9