Filter
Top Products
Rimage AutoPrinter
10 110656_H
b. If the disc is not centered on the print
pad, align the printer side to side.
i. Using the T25 Torx screwdriver,
loosen the two side to side
alignment screws.
ii. Slide the printer, not the printer
tray, until the side edges of the
disc and printer pad are aligned.
iii. Tighten the two side to side
alignment screws.
c. Using either a T25 Torx driver or a
5/32” Allen wrench, turn the front to
back alignment screw until the disc
hangs over the edge of the print pad by
0.010” – 0.015” (0.25mm – 0.38mm).
Side to Side Alignment Screws
Front to Back
Alignment Screw
Print Pad
5. When the printer is aligned, slide the lift arm to the top the unit.
6. Press the printer button to close the printer tray.
7. Press the disc release button to release the disc from the gripper.
# Tip: Place your hand under the disc to catch it.