Filter
Top Products
Operate the AutoPrinter
Operate the AutoPrinter
Installing the carousel
- Important: To prevent errors, the carousel should be installed before operating the software
or powering on the AutoPrinter.
1. Slide the carousel into the unit so that
the shaft slides in the slot opening of
the bearing guide.
2. Lower the carousel with the top
support bearing dropping in to the
bearing guide.
3. If necessary, rotate the carousel to seat
the carousel securely.
Top Support Bearing
Bearing Guide
Shaft
Powering on and off
Before you begin:
The carousel must be installed before you power on the system. For more information about
installing the carousel, refer to
Installing the carousel on page 5.
Note: The Prism printer power switch must be in the ‘on’ position. The Everest printer does
not have a power switch. The Everest printer is powered on when the AutoPrinter is powered
on.
The Everest printer takes 1 to 2 minutes to complete the initialization.
1. To power on the AutoPrinter, press the power
switch on the rear of the AutoPrinter.
Power Switch
2. To power off the AutoPrinter, press the power
switch.
110656_H 5