Filter
Top Products
Maintain the AutoPrinter
Maintain the AutoPrinter
Installing ribbons
Before installing ribbons in the printer, stop any operations.
To change ribbons in a Prism printer, refer to the PrismPlus Printer User Guide.
To change ribbons in an Everest II printer, refer to the Everest II Printer User Guide.
Cleaning method and schedule
Task Frequency
Once a week. Remove dust from the AutoPrinter and
surrounding work area.
Cleaning the AutoPrinter
Upon installation and again if the discs are not picked
correctly from the printer tray. Refer to the procedures below
for more information.
Aligning the printer
Aligning the printer
Everest printer
To align your Everest printer, use the following instructions.
# Required tools:
• T25 Torx screwdriver
• 5/32” Allen wrench
1. Power on the AutoPrinter.
2. Wait for the unit to complete initialization. When initialization is complete, the active indicator
light on the Everest printer illuminates.
kes 1 to 2 minutes to complete the initialization. Note: The Everest printer ta
3. Prepare the unit for alignment.
a. Manually slide the lift arm to the top of
the AutoPrinter.
b. To place a disc in the gripper, press
the disc up into the gripper while
pressing the disc release button.
c. Release the disc release button. The
Lift
Arm
Gri
pp
e
r
Disc Release Button
gripper holds the disc.
d. Press the printer button to open the
printer tray.
110656_H 7