Filter
Top Products
Maintain the AutoPrinter
Prism printer
To align your Prism printer, use the following instructions.
# Required tools:
• T25 Torx screwdriver
• 5/32” Allen wrench
1. Power on the AutoPrinter.
Note: If the Prism power switch is in the on position, power on both the printer and the
power switch.
AutoPrinter by pressing the AutoPrinter
2. Wait for the unit to complete initialization.
3. Prepare the unit for alignment.
a. Manually slide the lift arm to the top of
the AutoPrinter.
b. To place a disc in the gripper, push
the disc up into the gripper while
pressing the disc release button.
c. Release the button. The gripper holds
the disc.
d. Press the printer button to open the
printer tray.
4.
Lift
Arm
Gri
pp
e
r
Disc Release Button
Align the printer.
a. Slowly slide the lift arm
down until the disc just
touches the print pad.
Lift
Arm
Side to Side
Ali
g
nment
Print
Pad
Holding Pins
Printer
Button
110656_H 9