Filter
Top Products
INSTALLATION – SOLAR CONTROL UNIT
• Insulate the air bleed valve and non return valve assembly (11), from the solar hot pipe to the solar
hot water inlet of the solar storage tank, with the 150 mm long x 35 mm diam insulation (13) and
secure with the cable ties (14) provided.
Note: Use thread sealing tape or an approved thread sealant on all fittings.
to solar
collectors
from solar
collectors
refer to the installation
diagram on page 25
for
assembly details of solar
hot and solar cold pipe
connections
Solar Storage Tank with Solar Control Unit
SUPPLIED IN SOLAR
CONTROL UNIT KIT
1. Hex nipple ½” X ½”
2. 4 way tee
3. Hex nipple ½” x ¾”
4. Preformed pipe DN15
5. Compression nut
6. Olive
7. Circulator
8. Solar control unit
9. Screws
10. Cold sensor probe
11. Air bleed valve and non
return valve assembly
12. Insulation 280 mm long x
12 mm diam
13. Insulation 150 mm long x
35 mm diam
14. Cable tie
25