Filter
Top Products
23
Operating (cont’d)
5. This appliance is equipped with a device which auto-
matically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
6. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow “B” in
the safety information above on this label. If you don’t
smell gas, go to the next step.
7. Turn on all electrical power to the appliance.
8. Set the ON/OFF switch on the control box to the “ON”
position.
9. Set the thermostat to desired setting by first pressing
the COOLER and HOTTER buttons together
and holding for 1 second. Then press the HOTTER
button .
10. WATER TEMPERATURE ADJUSTMENT is
approximately 120˚F.
CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
11. If the appliance will not operate, follow the instruc-
tions “TO TURN OFF GAS TO APPLIANCE” and
call your technician or gas supplier.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING
1. STOP! Read the safety information above
on this label.
2. Set the ON/OFF switch on the control box to the “ON”
position.
3. Set the thermostat to the lowest setting by first press-
ing the COOLER and HOTTER buttons
together and holding for 1 second. Then press the
COOLER button until the WARM indicator light
appears.
4. Set the ON/OFF switch on the control box to the
“OFF” position.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
1. Set thermostat to the lowest setting by first pressing
the COOLER and HOTTER buttons together
and holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
2. Set the ON/OFF switch on the control box to the
“OFF” position.
3. Turn off all electric power to the appliance if service
is to be performed.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in the gas control but-
tons. Never use tools. If the control buttons will not
push in, don’t try to repair them, call a qualified ser-
vice technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights the
burner. Do NOT
try to light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
WARNING:
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss
of life.
HOTTER
COOLER
C
C
B
B
A
A
HOT
VERY
VACATION
WARM
--------------
-----------------------
----------------------
------------------------------
------------------------------------------------------
* -----------------------------------------------------------------------
* ----------------------------------------------------------
--------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------
* ------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------
TO TURN OFF GAS TO APPLIANCE
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING