Filter
Top Products
ASSEMBLY INSTRUCTIONS: DOWNROD, CANOPY, AND COLLAR COVER
1. Carefully support fan housing (motor) in its styrofoam packing with the mounting collar (where the wires come
out) facing upward.
2. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin;
remove ball. The 6˝ downrod is recommended (if clearance above floor allows) to provide greater air flow, since
more space will be available above the blades for supply air.
3. Feed the wires from top of fan through the end of the downrod you have selected, and set end of downrod into
mounting collar so the hole in the downrod lines up with the hole in the side of the mounting collar.
4. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod pin in place.
5. Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
Then tighten lock nuts against mounting collar.
NOTE: Fan has 6 feet of hook-up wire in case you
are using a long extension downrod. Wires can be
cut so only 8 inches or so extend beyond the top
of the downrod to make the electrical connections
easier and safer.
6. Feed wires through and slide collar cover
down the downrod to top of fan.
7. Feed wires through canopy and slide
canopy over downrod to lay on top of collar
cover. It will be attached to ceiling later.
8. Feed wires through ball and slide ball over
downrod, past hole in the top end of downrod.
Insert ball pin (removed in Step 2), slide ball
up and tighten set screw to secure ball in place.
9. Install 4 candelabra base bulbs (E12, 25w
max) in sockets.
Ground
Wire
Hook-up Wires (3)
Ball
Collar Cover
Security Screws
Mounting Collar
Downrod
Pin
Cotter Pin
Fan
Housing
Canopy
Downrod
E12 bulbs
5