Filter
Top Products
3. After you have preset the code selectors, insert the terminal connector from the fan motor into the terminal
connector inside the receiver (Fig. 2). The terminal plug can only be inserted one way to prevent improper
connection.
5. Secure the receiver housing to the mounting hub by sliding the housing onto the 3 screws on the hub and
turning clockwise. Tighten the 3 screws when in place.
4. Insert the antenna wire through one of the
small holes in the switch housing hub.
(Fig. 3) For best reception of the transmitter’s
signal the antenna should be fully extended
outside of the switch housing.
SWITCH HOUSING RECEIVER
FAN’S SWITCH HOUSING HUB
ANTENNA
ANTENNA
MOUNTING HUB
FIG. 3
FIG. 2
TERMINAL CONNECTOR
11
REMOTE CONTROL CONTINUED (OPTIONAL)