Filter
Top Products
PREPARATION:
Verify that you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor from
packing. To avoid damage to finish, assemble motor on soft padded surface or use the original foam inset in motor box. Do not
lay fan on its side as this could result in shifting of motor in decorative enclosure.
Caution: To avoid possible electrical shock, be sure
electricity is turned off at the main power box before
wiring. All wiring must be in accordance with National
and Local Electrical Codes and the ceiling fan must be
grounded as a precaution against possible electric shock.
1. Locate ceiling joist where fan is to be mounted, being
sure location agrees with the requirements in the min-
imum clearance section of this guide. Wood joist
must be sound and of adequate size to support 35 lbs.
(p. 1, #3 and #4)
2. If not already present, mount a UL listed outlet box
marked “suitable for fan support” following the
instructions provided with the outlet box. The outlet
box must be able to support a minimum of 35 pounds.
3. Attach hanger bracket to outlet box using screws
provided with the outlet box.*
PREPARATION
4
Parts identification on assembled fan
INSTALLING THE MOUNTING BRACKET
Downrod
Canopy
Fan Housing
Blade
Blade Arm
Ceiling Fan
Outlet Box
Hanger
Bracket
Outlet Box
Screw
Flat Washer
Spring Washer
Washer Nut
* Parts other than hanger bracket are
supplied with outlet box.
Detachable Switch Housing