Filter
Top Products
IMPORTANT: PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the appliance on.
It is normal for fireplaces fabricated of steel to give off some expansion
and/or contraction noises during the start up or cool down cycle.
It is not unusual for the Raypak Vermont gas fireplace to produce some
odour the first time it is burned. This is due to residual oils used during the
manufacturing process.
Please open all windows to ensure your room is well ventilated.
It is recommended that you burn your fireplace for at least 10 hours the
first time you use it. Please turn the fan switch in the OFF position during
this initial firing.
Fig. 1 Locating Your Gas Fireplace
A) Flat on wall* B) Room divider* C) Island
D) Cross corner E) Flat on wall corner
Warning: There is a minimum vertical rise required for the venting,
which varies depending on the application. The maximum horizontal
run also has restrictions. Before starting the installation read the
venting instructions in this booklet and refer to AS5601. The
minimum vertical rise for this appliance is 3m.
Clearance to Combustibles: Adequate clearances as listed below must
be maintained for servicing and proper operation.
Back…………………………0 mm
Side………………………305 mm
Floor………………………...0 mm
Top……………………….915 mm
Corner………………………0 mm
Flue Pipe………………….25 mm
Page 6 of 27