Filter
Top Products
Flame and Temperature Adjustment
The appliance is fitted with the Honeywell Radio Frequency control valve and
all adjustments are performed with the use of a remote controller.
See instructions packaged with the Remote Controller or refer to page 16 in
this manual for operating instructions.
Flame Appearance
Periodically perform a visual check of the pilot and burner flames by
comparing them to the illustrations below (refer to figures 4 and 5). If any
flames appear to be abnormal, place a service call.
Fig 4. DVT pilot flame
Fig.5 RFSDV34 flames
Lighting Instructions
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a
fire or explosion may result, causing property damage,
p
ersonal in
j
ur
y
or loss of life.
A. This heater has a pilot which must be lit manually. To light the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING, smell all around the heater area for gas. Be
sure to smell next to the floor as some gas is heavier than air and
will settle on the floor.
C. What to do if you smell gas:
• DO NOT try to light any fireplace.
• DO NOT touch any electrical switch.
Page 13 of 27