Filter
Top Products
R
September 1, 2008
7034-106E
Page 33
Mt. Vernon Pellet Stove (AE)
Va m o t the e ha st area
Loosen all n ts t do Remove
f. Removing the Combustion (Exhaust) Blower
1. The combustion blower is mounted in the bottom
right rear of the appliance. Figure 33.1.
2. Use an 11/32 nut driver to loosen all six nuts, but do
not remove. Rotate the blower and remove from the
housing. Figure 33.2.
3. Set the blower on the top of the housing. You do not
need to disconnect the wires. Figure 33.3.
4. Vacuum out the exhaust area. Figure 33.4.
Figure 33.1
Figure 33.2
Figure 33.4
Combustion Blower
Set lo er on top of ho sing
o not dis onne t the ires
Figure 33.3