Filter
Top Products
R
September 1, 2008
7034-106E
Page 25
Mt. Vernon Pellet Stove (AE)
WARNING
Fire Risk
Do NOT operate appliance:
• With appliance door open.
• With Firepot floor open.
Do NOT store fuel:
• Closer than required clearances to com-
bustibles to appliance.
• Within space required for loading or ash
removal.
Fire Risk
Keep combustible materials, gasoline
and other flammable vapors and liquids
clear of appliance.
WARNING
• Do NOT store flammable materials in the appliance’s
vicinity.
• Do NOT use gasoline, lantern fuel, kerosene, charcoal
lighter fluid or similar liquids to start or “freshen up” a
fire in this heater.
• Keep all such liquids well away from the heater while it
is in use.
• Combustible materials may ignite.
You can operate the appliance from any of the 5 levels. On
the lowest level, the appliance will stay on longer, burn less
fuel per hour, but will take longer to bring the home up to
your desired temperature. On the highest setting, the appli-
ance will burn more fuel per hour, but bring your home up to
temperature more quickly.
Regardless of the heat output level, when the home reaches
your set temperature, the appliance will go into the shut
down cycle. In Manual mode heat output does not change.
Turn to OFF to stop operation.
4. Shutdown
Once your home has reached your set temperature, the
appliance will stop feeding fuel and allow the fire to dimin-
ish. The convection blower will continue to run until the
appliance cools to appropriate temperature and will go into
the auto-clean cycle.
5. Auto-Clean
The firepot auto-clean system will cycle when the appliance
is first plugged in:
• When the house reaches temperature and the appli-
ance shuts down.
• At prescribed intervals, depending on the type of fuel
selected.
If your appliance is running and the auto-clean cycle is initi-
ated, the appliance will revert to shut down cycle.
The floor of the firepot will open and deposit the ash into the
ash pan. It takes approximately 2 minutes to complete the
auto-clean cycle. The floor will then shut, and if the thermo-
stat is still calling for heat, the fire will start again, continuing
the heating process.
During this auto-clean cycle, the convection blower will con-
tinue to run.
Additional Screen Messages:
READY It is telling you that the home is up to temperature
and does not need any heat.
- - - - - The screen will show 5 dashes when the wall
control and the control board are NOT communicating with
each other. Check that the wiring on the thermostat is prop-
erly connected.
MAINTENANCE BURN The maintenance burn is to keep
the system from shutting down when operating on battery
backup. The appliance will not automatically re-light in
manual mode.
OFF The AUTO/MANUAL SETTING screen has been set
to OFF. Set the appliance to OFF when performing periodic
maintenance to prevent an unexpected startup.
3. Auto / Man - L, ML, M, MH, H (Cont’d)