Quadra-Fire CB1200I Indoor Fireplace User Manual


 
Page 20
7014-188B
February 3, 2010
R
CB1200-I Pellet Insert
R
R
B. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x 3 ft. ex hose,
1 hose clamp and 1 rodent screen.
1. Measure distance from oor to air vent opening in appli-
ance and mark location on wall.
2.
Use saw to cut opening in wall. Cut a 2-1/2 to 3 inches
(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.
3. Use hose clamp to secure ex pipe to collar assembly.
4. Slide trim ring over ex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second
hose clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Tools Needed: Phillips head screw driver; wire cutters;
hole saw or jig saw.
CAUTION
Never draw outside combustion air from:
Wall, oor or ceiling cavity
Enclosed space such as an attic or garage
Flex Hose
Hose Clamp
Collar
A
ssembly
T rim Rin g
Hose Clamp
Termination
Cap Assembly
Figure 20.1
Attach hose clamp to
intake air collar
Outside air
flex pipe
D. Grille Installation
Figure 20.3
1. Remove grille from packaging.
2. Lift top up.
3. Align the 3 holes in the insert with the holes in the grille.
4. Use a Phillips screw driver to secure in place. It will be
necessary to go through the hole in the bag support shelf
to gain access to the screw. Figure 20.3.
5.
Lower the top into position.
Bag Support Shelf
C. Adjustable Hopper Options
Depending on your installation, the hopper can be vertically
adjusted up to a maximum of 3-1/2 inches (89mm) and will
hold an additional 15 lbs of fuel.
To adjust hopper:
1. Using a Phillips head screw drive, remove all the screws
from the top of the hopper securing the top hopper piece
to the bottom hopper piece and insert body.
2. Adjust upward a maximum of 3-1/2 inches (89mm).
3. Mark location for new holes and drill new holes.
4. Secure hopper pieces together using screws removed in
step one.
5. See drawing on page 8, Figure 8.3.
Figure 20.2