Filter
Top Products
PREMIER SX USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Approved Document No: GLT.MAN-102
PAGE 9
Issue: 1.3 Authorised: GH Date: 9/6/2004
6.2 WHAT TO DO IF A FAULT CONDITION OCCURS
If a fault occurs, the responsible person should:
• Turn keyswitch to Controls enabled and press silence flt tone button (button 2) to silence the fault buzzer.
• Write down the fault (s) in the Log Book at the back of this Manual. Take appropriate action to correct the fault
(Usually by contacting the service engineer)
On the Premier SX panel, the fault indications (except system fault) are non latching. That is, when the fault has been
cleared, the fault indication will turn off. When all faults have been cleared, the panel will return to its quiescent (normal)
condition.
When a fault has been rectified the indicator light for that Fault is automatically turned off. If all Faults are cleared, the
General Fault light will go out and the Panel’s Internal Sounder will be silent (if not already muted).
Earth Fault
The Earth Fault light flashes when the panel detects an earth
fault (short circuit to earth) on the wiring to any part of the
control panel.
Sounder Fault
The Sounder status light flashes when there is a wiring fault
on the Sounder Circuits. Depending on where the fault
has occurred, one or all of the Alarm Sounders may no longer
be operative.
If the fault is a short circuit fault, then the S/C LED will also
be lit.
POWER
GEN-FIRE
GEN-FAULT
SUPPLY FLT
SYSTEM FLT
GEN-S/C
DEL
GEN-ZONE TEST
GEN-DISABLEMENT
1
8
765432
18765432
FIRE / ZONES
ZONAL FAULT / DISABLEMENT / TEST
12
3
4
ENGINEER
STOP-START SILENCE RESET SCROLL /
/ LED TEST
FLT TONE
DELAY
OVERRIDE
FLT
POWER
GEN-FIRE
GEN-FAULT
SUPPLY FLT
SYSTEM FLT
GEN-S/C
DEL
GEN-ZONE TEST
GEN-DISABLEMENT
1
8
765432
18765432
FIRE / ZONES
ZONAL FAULT / DISABLEMENT / TEST
12
3
4
ENGINEER
STOP-START SILENCE RESET SCROLL /
/ LED TEST
FLT TONE
DELAY
OVERRIDE
FLT