Filter
Top Products
PREMIER SX USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Approved Document No: GLT.MAN-102
PAGE 5
Issue: 1.3 Authorised: GH Date: 9/6/2004
4. PANEL INDICATIONS & CONTROLS
POWER
GEN-FIRE
GEN-FAULT
SUPPLY FLT
SYSTEM FLT
GEN-S/C
DEL
GEN-ZONE TEST
GEN-DISABLEMENT
1
8
765432
1
8
765432
FIRE / ZONES
ZONAL FAULT / DISABLEMENT / TEST
12
3
4
ENGINEER
STOP-START SILENCE RESET SCROLL /
/ LED TEST
FLT TONE
DELAY
OVERRIDE
FLT
OFF
CONTROLS
ENABLED
Two levels of control are available to the User(s) of this Fire Alarm Panel.
4.1 GENERAL CONTROLS
When the Panel is in its Normal state, the indicator lights on the front of the enclosure give a
comprehensive overview of the System’s current status. Any Fire and Fault conditions are clearly
displayed, and any disablements highlighted. For detailed descriptions of what each indicator means,
please refer to the table on the opposite page.
The only functions that can be performed by the User when the Panel is in its Normal state are:
• Overriding any Delays, which may have been programmed into the Panel by pressing the
Sounder Override button.
• Putting the Panel into the Accessed state – see below.
4.2 ACCESSED CONTROL (AVAILABLE TO AUTHORISED USERS ONLY)
To avoid unauthorised changes to critical parts of the Fire Alarm System, controls such as silencing
the Sounders, resetting an Alarm condition and implementing Disablements are only accessible via a
secure method of entry which puts the panel into the Accessed state.
To put the Panel into the Accessed State: Turn the key to the control enable position (please note
the key should not be removed when in this position). To leave the Accessed state, turn the key back
to the off position.
Information on how to used the accessed control can be found on Pages 8 to 11 of this User Manual.