Philips AC4083 Air Cleaner User Manual


 
- The battery of the remote control contains substances that may
pollute the environment. Do not throw away batteries with the normal
household waste, but dispose of them at an ofcial collection point for
batteries. Always remove the battery of the remote control before you
discard and hand in the appliance at an ofcial collection point.
Guarantee and service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Consumer Care Centre
in your country (you nd its phone number in the worldwide guarantee
leaet). If there is no Consumer Care Centre in your country, go to your
local Philips dealer.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Problem Possible solution
The light of the air
quality indicator disturbs
my sleep.
Set the appliance to AUTO mode. When the room is dark, the appliance
automatically switches from AUTO mode to night mode. In night mode, the
air quality light is out. The appliance also operates quietly to allow you to
sleep undisturbedly.
The water bucket leaks. It is normal that the bottom of the water bucket is slightly wet when you
remove it from the appliance, because the water bucket is in contact with the
water tank. However, if water drops keep dripping from the bottom of the
water bucket, check if the top cap and the bottom cap have been screwed
onto the water bucket tightly. If the problem persists, contact the Consumer
Care Centre in your country.
The water level in the
water bucket drops
very quickly after I
empty the water tank.
This is normal. The water in the water bucket is used to ll the water tank
and the humidication lter also absorbs some of the water.
The appliance does not
work even though it is
switched on.
The water tank is not placed properly. In this case the appliance does not
work and the CURRENT HUMIDITY lights ash. Switch off the appliance.
Remove the water bucket and then remove and reinsert the water
tank. Then switch on the appliance and try again.
The appliance does not
work.
You ignored the lter replacement indications. You did not replace a lter
when the corresponding lter replacement light ashed and did not respond
when the appliance beeped every 30 minutes to remind you to replace a
lter. As a result, the appliance is now locked and you have to replace the
lter and reset the appliance (see chapter ‘Filter replacement and reset
procedure’) so that the appliance can provide healthy air again.
ENGLISH 27