Filter
Top Products
12
Cutting the
Screen Housing
F
Upper Housing Assembly
Lower Housing
Assembly
Washer
G
Inner Handle
Bottom Rail Guide
Side Bar Cushion
Side Bar
H
NOTE: All cutting will be done on the lower end of the Screen Housing,
away from the Upper Housing Assembly and spring mechanism.
The Screen is clearly labeled with CUT and NO CUT zones.
1. Begin by tightening the screw at the top of the Upper Housing
Assembly . This will align the Mesh Cylinder for cutting.
2. Remove the Lower Housing Assembly and washer by removing the two
screws with a Philips screwdriver.
3. Slide the Side Bar Cushion off of the Side Bar and slide the Bottom
Rail Guide off of the Screen Housing .
F
G
H
1
1