Filter
Top Products
Adjustment
22
1.04.13 Height of the feed wheel (on the PFAFF 591)
Requirement
The feed wheel should protrude from the needle plate by tooth height (approx. 0.8 mm)
● Swing out the roller presser.
● Loosen screws 1.
● Adjust eccentric 3 (fastening screw accessible through hole 2) according to the require-
ment.
● Tighten screws 1.
61-035
Fig. 1 - 13
1
3
2
61-039
0,8 mm