Filter
Top Products
Setting up
26
Fig. 9 -02
4
6
1
2
3
5
9.02 Winding the bobbin thread, regulating the winder tension
● Place an empty bobbin 1 on winder spindle 1.
● Thread up as shown in Fig. 9-02 and wind the thread a few ttimes clockwise around
bobbin 1. Engage the bobbin winder by pressing spindle 2 and lever 3 simultaneously
The bobbin is wound during sewing.
● The tension of the thread wound onto bobbin 1 is set on knurled screw 4.
● The bobbin winder will stop when suffi cient thread is wound onto bobbin 1.
If the thread is wound on unevenly:
● Loosen nut 5.
● Turn thread guide 6 as required.
● Tighten nut 5 again.