Filter
Top Products
Setting up
25
9 Setting up
All instructions and regulations in this instruction manual must be observed.
Special attention must be given to all safety regulations!
All setting-up work must only be done by personnel with the necessary train-
ing. For all setting-up work the machine must be isolated from its power supply
by turning off the on/off switch or removing the machine plug from the electric
power socket!
Fig. 9 - 01
1
2
Fig. 9 - 01a
2
1
PFAFF 1246
● Set needle bar at top position and loosen
screws 1.
● Push needles 2 fully in (the long groove
of the left needle must face to the right
and that of the right needle to the left).
● Tighten screws 1 again.
PFAFF 1245
● Set needle bar at top position and
loosen screw 1.
● Insert the needle as far as possible
(the long needle-groove must be
facing left).
● Tighten needle retaining screw 1.
Switch the machine off!
Danger due to unintentional starting of the machine!
Only use needles from the system intended for the machine, see Chapter 3
Specifi cations.
9.01 Inserting the needle