Filter
Top Products
Adjustment
7
1.05 Adjusting the basic machine
1
.05.01 Basic position of the machine drive
This adjustment is only required if toothed belt 2 has been removed.
● Turn toothed belt sprocket 1 according to Requirement and push on toothed belt 2.
When installing the motor pay attention to the correct position of shaft fl ange,
shock absorber and motor fl ange!
Requirement
When the needle bar is positioned 0,6 mm past b.d.c., the markings 3 and 4 should be in
alignment..
Fig. 1 - 02
1
4
3
2